When viewing the entire routing table, how can you distinguish between a directly attached static route and a directly connected network?Ī. Which command only displays the static routes listed in the routing table?ĭ. Which command only displays directly connected networks?Ĭ. How does a directly attached static route differ from a recursive static route? Configure a directly attached static route from R2 to every network not directly connected.ī. Step 2: Why were you unsuccessful? Configure directly attached static routes on R2.Ī. Test connectivity to the R2 LAN and ping the IP addresses of PC2 and PC3. Configure a recursive static route to every network not directly connected to R1, including the WAN link between R2 and R3.ĭ.
Why does a recursive static route require two routing table lookups?Ĭ. Step 1: Configure recursive static routes on R1.ī. Test connectivity to the R2 and R3 LANs by pinging PC2 and PC3 from PC1. How many static routes are required by each router to reach networks that are not directly connected?ĭ. How many networks are directly connected to R1, R2, and R3?Ĭ. Looking at the topology diagram, how many networks are there in total?ī. There are four different static routes that are used in this activity: a recursive static route, a directly attached static route, a fully specified static route, and a default route.Ī. A static route is a route that is entered manually by the network administrator to create a reliable and safe route. In this activity, you will configure static and default routes. Part 2: Configure Static and Default Routes
Part 1: Examine the Network and Evaluate the Need for Static Routing